Darkglass Electronics Darkglass Electronics Microtubes Infinity Bass Preamp/Overdrive Pedal
Presenting the all new Darkglass Electronics Microtubes Infinity Bass Preamp & Overdrive Pedal.The Microtubes Infinity shares the footmark of Darkglass's programmable line, packed with three of the legendary Microtubes distortions: B3K, Vintage, and X. Moreover, it allows multiband compression on every mode, blending Impulse responses between distortions while adding extra controls via the Darkglass suite for an endless number of features: An infinity of possibilities. Compression: The Compression potentiometer is the one-knob solution for compression on the Microtubes Infinity. This controls the amount of input gain to the compressor and intelligently applies the correct amount of makeup gain so that your signal is always driven at the appropriate level, no matter how much compression is applied. Drive: The Drive potentiometer adds distortion and drive to our signal (modes 2-5) or blends in the tube preamp emulation (mode 1). Crank this knob to add more saturation or character to your distortion/preamp part of the signal chain. Tone·Era: The Tone·Era potentiometer allows you to go from dull to crisp and anything in between. On the Vintage Microtubes (modes 2 & 4) you get the coveted ERA control which covers different decades of classic bass tones. Blend: The Blend potentiometer mixes between the distortion signal and the clean sidechain signal. Level: The Level potentiometer controls the master volume of the Microtubes Infinity. Touch Sensitive Sliders: Each slider has a -12 dB to 12 dB range. From left to right, the frequency bands for each slider correspond to a low shelf, 250 Hz, 500 Hz, 1.5 kHz, 3 kHz, and a high shelf. Input: This is the primary instrument input on the Microtubes Infinity. Connect your instrument or output from your pedal board to the 1/4” mono jack. Aux In: The stereo input of the Microtubes Infinity enables the playback of backing tracks while practicing or recording. Connect your mobile phone, laptop etc. to the 1/8” stereo jack. Headphone Output: The headphone output can handle headphones with an impedance of 16 - 600 ohms. Connect your headphones to the 1/8” stereo jack and set the desired level from the dedicated potentiometer next to the jack. Balanced Outputs: The two balanced outputs add routing versatility and the option of using the Microtubes Infinity as a fully equipped audio interface. Connect your studio monitors, amplifier or other effects to the 1/4” balanced jacks using a TRS connector (Tip +, Ring -, Sleeve GND). If you feed an unbalanced input from these outputs, use an instrument cable with a mono 1/4” plug. Direct Output: An XLR output with a ground lift switch provides a reliable standard connection to a mixing desk or an external audio interface for a guaranteed low-noise signal. MIDI In: A standard 1/8” TRS (Type B) jack allows connecting an external MIDI controller to the Microtubes Infinity for even more flexibility. USB: The USB-C port unlocks the Microtubes Infinity’s USB audio interface capabilities and enables interaction with the Darkglass Suite desktop app, allowing for software updates and access to the Darkglass IR library, containing hundreds of cabinet simulations. USB MIDI is also supported. DIMENSIONS: 180x120x60 mm | Weight 0.7 kg WARNING: The Microtubes Infinity has a current draw of ~500mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty
The Guitar Sanctuary
We accept all major credit cards (orders must ship to the billing address of the cardholder or authorized ship-to address for their account), PayPal (shipped to a PayPal confirmed delivery address), Financing through Blispay, Wire Transfer in advance in US Funds, or COD (Cashier's Check only).
We ship most any order placed before 3pm CDT Tuesday through Friday the same day. Orders placed Saturday-Monday will ship the following Tuesday. For new products we will only ship to delivery addresses within the United States. Most pedals are shipped via Priority Mail. Guitars and Amplifiers are shipped via UPS Ground. Other shipping methods are available. Please contact prior to placing your order for shipping cost quotations to your delivery address.
The Guitar Sanctuary does accept returned items as long as arrangements are made for such within 48 hours of purchase/receipt. Returned items MUST be in the original condition and packing (including owner’s manual, un-used warranty card, any other items that came with the item) in order to qualify for a refund. No refunds are available for “special” ordered guitars or amplifiers (items that were not in stock, but rather ordered per the customers request. The customer is responsible for all freight charges and credit card processing fees incurred in the course of the sale. We cannot refund freight charges. The Guitar Sanctuary will charge a 20% restocking fee for returned effects pedals and amplifiers and a 10% restocking fee for Guitars. The only exceptions are for products that are defective. Please only purchase an item after you are certain it is right for you! Layaway: You can lay-a-way any product for a maximum of three months. Lay-a-way requires a 25% non-refundable deposit. We will not be able to ship the item until it is paid for in full and as a lay-a-way purchase, does not qualify for the 48 hour approval policy. International Sales: We can ship most guitars and other products internationally. We prefer money orders, cashier’s checks, or bank wire transfers in U.S. dollars. Shipping quotes are only valid for 48 hours. Please consult with your local officials about taxes, duties, currency exchange rates, etc.