Description

Fuchs Audio Plush Crem de la Trem FX Pedal

Description:

Analogue Vintage Brownface Tremolo

Manufacturer Description:

The Plush “Crème de la Trem” is a unique tremolo pedal, which is designed to emulate the sound of the 

highly desirable Brown face Fender Tremolo’s of the 50’s and 60’s. These tremolos were truly unique, in 

that they produced not only a level variation, but also altered pitch. This is often compared to modern 

day chorus pedals, or rotary speakers. The “Crem de la Trem” is a unique product, designed by Andy 

Fuchs. It uses a unique circuit topology which uses a combination of IC’s, combined with FET’s to 

emulate the vintage Tremolo tones of the 60’s Brown face Fender amps. It is designed for lowest noise 

and the warmest most neutral and tube like tones possible. 

The unit is activated when a standard ¼” guitar cable is plugged into the input jack. If using this unit on 

battery power, the guitar cable should be unplugged when it’s not in use, to extend battery life. 

The Plush “Crem de la Trem” is an easy to Tremolo unit. The rate knob sets the speed of the tremolo, 

while the intensity knob adjusts how strong the effect is. From a subtle amount of modulation, to an 

extreme warble, these controls will allow you to dial the exact vintage tones you seek.  

PLUSH, a division of Fuchs Audio Technology 

 407 Getty Avenue | Clifton, NJ 07015 | Ph. 973-772-4420 | Fax 973-772-4460 | info@fuchsaudio.com 

www.plush-pedals.com www .fuchsaudiotechnology.com 

A tremolo may be inserted at various points in your pedal board or signal path. We suggest placing the 

unit at the end of any pedal board signal chains. 

The input impedance is 1-Meg, which is universally considered an excellent match for most guitars. The 

output impedance is approximately 1-K, which is buffered, to drive long cables as well as subsequent 

effects. 

 The Plush “Crème de la Trem” provides a true hard wire bypass, which means when not in use (LED not 

lit) the input is connected directly to the output, with no loading of the signal, and no active devices in 

the signal path. 

The DC jack on the side is a standard 2.1 mm tip negative adaptor input. A Plush DC adaptor may be 

purchased from your local dealer or any standard Roland, Goldlyke, or similar style DC adaptor may be 

used. The output of the adaptor must be 9-Volts DC. Using this pedal with the incorrect adaptor may 

potentially damage the pedal, which will not be covered under warranty. 

This Plush product is designed for years of reliable service, and there are no user serviceable or 

replaceable parts inside. Service should be obtained via our factory or the distributor from which you 

obtained the pedal, in the event of a product failure

 

Sound Pure
Durham, NC
10:39 AM
10am-6pm EST Monday-Friday and 11am-5pm Saturday