Nice original 50s LG2; x braced, warm open tone. Two small screw holes filled in the rosette ( from a pickup) , otherwise straight with no issues or alterations.

A very fine sounding classic herringbone D-28. This guitar has had a pro neck set and refret at Brothers guitar repair , as well as a replaced pickguard and bridge plate. The whole guitar shows overspray and some touch up to cover a removed larger pickguard . Now for the good news…. It sounds and...

A fine and rare Olcott Bickford model 0-44. The 44 series was designed to have premium 45 grade woods while eschewing the pearl ornamentation of the the 45 series. The guitar has been set up perfectly by Ken Fallon and all issues addressed . There is an older top crack repair and touch up around a...

A very fine sounding 50s J-200.just refretted and set up by Tom Crandall,so it’s plays easily and sounds as it should. Repaired top crack below the bridge and a pickguard crack. Some touchup , but otherwise original . A classic Gibson.

A very fine , crack free early 1950s D-28. Beautiful Brazilian rosewood back and side, fine Sitka spruce top. Correct replacement bridge ; pro neck set and refret. A very responsive and easy to play guitar . Lovely tone .

Lovely and original Style U harp guitar. All components are intact . There is one hairline crack on the top to the treble side . Otherwise there are cracks or repairs. Huge resonance.

Handmade by James Olson, this guitar is in unplayed ! Mint condition.the specs are just like the James Taylor model , except for the abalone back strip and end wedge; Western Red Cedar top, Select Indian Rosewood back and sides, multi laminate neck, abalone top inlay and rosette, Dove fingerboard...

A fine crack free example . Converted by noted luthier TJ Thompson . Fine sound and setup . A little wear where a pickguard would be , otherwise extremely clean guitar.

This is a new smaller sized a Klein that I helped to design. The model designation is the width in cm, so about 15 1/2 “ wide. The revised spec is a shallower body , a 14 fret neck, 1 3/4” nut and a mahogany neck with ebony fingerboard. This is the prototype and it was made with an Engelmann...